Infinity stops for MicroPress

This section is for M.P.P. Members to sell, swap or seek M.P.P. items...
Post Reply
Roland
Posts: 19
Joined: November 8th, 2018, 7:44 pm

Infinity stops for MicroPress

Post by Roland » January 25th, 2019, 6:33 pm

For my MicroPress I only have one infinity stop.
Because of this the lens board does not always come out striaight.
So one additional infinity stop would already be very welcome!
Where could I buy one?

Of course, for a second and third lens additional infinity stops would be most welcome as well.
I could test a Graflex infinity stop; it fitted in the MicroPress rail very well, but was too short to block the lens carrier.

IanG
Posts: 73
Joined: December 23rd, 2016, 11:31 am

Re: Infinity stops for MicroPress

Post by IanG » February 1st, 2019, 4:28 pm

As the track & the front standard are identical to a 5x4 Pacemaker Graphic and are in fact made by Graflex the Pacemaker infinity stop should fit. However the track height varies between some Graflex models and Infinity stops differ. The Infinity stops of my Super Graphic are taller than a Pacemaker's and you cant fit a Super Graphic front standard on a Pacemaker track (same width) without grinding away part of the base of the standard (I know because I've done it).

Ian

Post Reply